Juno Junosol Water-Based Floor & Driveway Paint - White
Hazard informationNot classifiedcontains a sensitiser (EUH208), hazardous droplets when sprayed (EUH211)
Hazard information
Not classified as hazardous under CLP Regulation (EC) No 1272/2008. No hazard pictogram or signal word applies. The label carries the following statements:
- EUH208: Contains 1,2-benzisothiazol-3(2H)-one, reaction mass of 5-chloro-2-methyl-2H-isothiazol-3-one and 2-methyl-2H-isothiazol-3-one (3:1). May produce an allergic reaction.
- EUH211: Warning! Hazardous respirable droplets may be formed when sprayed. Do not breathe spray or mist.
Read the label and the Safety Data Sheet before use. The SDS is in the Datasheets section on this page. Hazard information taken from the manufacturer's Safety Data Sheet, revision 02.03.2022.
A concrete floor or a tarmac driveway is mostly a preparation job. Juno Junosol Water-Based Floor & Driveway Paint in White is a one-pack water-based paint for concrete, asphalt and tarmac, inside or out, for line marking, sports surfaces and car parks with light traffic. Abrasion resistant, with an anti-dust finish. Stocked in 4L and 15L. The finish is semi-matt, and the gloss varies with temperature and substrate absorption.
What the floor has to be before you start
- Strong enough, on concrete: surface tensile strength at least 15 kg/cm² and compressive strength greater than 25 N/mm².
- Rough and absorbent: free from grease, rubber, curing agents and lime-scale, sanded or ground to remove laitance, then vacuumed.
- Etched, if the concrete is smooth or silica-free: 10% hydrochloric acid with the proper safety measures, then jet-washed to remove the excess.
- Sanded over old gloss or satin, and adhesion-tested first.
- Asphalt and tarmac: clean, and a minimum 15 days after laying.
In any doubt, put down a 1 m² test patch first.
Conditions on site
- Temperature above 10°C: through application and curing.
- Relative humidity 80% maximum, and no rising damp.
- Substrate at least 3°C above the dew point.
- Substrate moisture under 4%.
- No rain or strong wind likely.
- Protected from water for 24 hours.
Coverage, drying and recoating
- Practical coverage 8 m²/L per coat: at the minimum two coats specified, about 4 m² of finished floor per litre, and less on porous or rough substrates.
- Touch dry in 1 hour: surface dry, not cured.
- Recoat from 6 hours: the datasheet gives the maximum repaint time as unlimited.
Putting it on
Brush the first coat, which the datasheet prefers for penetration; later coats by roller or spray. Thin with water to suit the surface and wash tools out with soapy water after use.
Where it has to be anti-slip
On its own Junosol carries no slip classification. Class 3 comes only with Juno Anti-Slip Microbeads (product code 07250) mixed in, so order those with it.
Ireland & Northern Ireland — 1–3 working days. Charged by total order weight, VAT included:
- Up to 30 kg — €6.99, or free on orders over €85
- 30–60 kg — €13.99
- 60–100 kg — €27.99
- Over 100 kg — pallet delivery €49.99
Great Britain — 2–4 working days. €13.95 up to 30 kg, then €27.90, €55.90 and €99.90 by the same weight steps. There is no free delivery to Great Britain.
Rest of Europe — non-liquid items only, from €11.75, priced by destination and weight at checkout. Paint and other liquids ship to Ireland, Northern Ireland and Great Britain only.
Dispatch and collection — in-stock orders placed before 12pm Monday to Friday ship the same day. Click & collect at Ballymount, Dublin 12 is free and often ready within the hour.
Returns — 14 days to change your mind and 14 more to send it back. Tinted paint is non-returnable once mixed.
